ATA 06 – DIMENSIONS AND AREAS
- Dimensions
- Fuselage Length – 123 feet approx
- Wing span – 117 feet approx
- Wing Sweep angle – (at 25% MAC) 24 Deg. 58′
- Tail height – 40 feet approx
- Fuselage Datum Lines
- X = Fore and aft distance from any point to STA0.
- Y = Lateral distance from any point to aircraft centerline.
- Z = Vertical distance from any point to aircraft centerline.
- Reference Axis
- Fuselage – The reference X=0 in the X-axis is located 100 inch (2.54m / 254cm / 2540 mm) forward of the aircraft.
- Wings – The reference axis is located at 73.54 in (1868 mm) from the aircraft X-axis.
- Vertical Stabilizer – The reference station is Z=0 at the vertical Z-axis.
- Horizontal Stabilizer – The reference station is Y=0 at the horizontal Y-axis.
- Station Numbers
- STA – The station (STA) number is the distance in millimeters of the cross-section from a reference point. Reference station is for all structural measurements.
- Use in production.
- Note: AMM tasks are station-wise.
- Section Numbers
- Use in manufacturing.
- Zones Numbers
- 100 – Lower half of the fuselage to the rear pressure bulkhead
- 200 – Upper half of the fuselage to the rear pressure bulkhead
- 300 – Empennage, including fuselage aft of the rear pressure bulkhead
- 400 – Power plants and struts or pylons
- 500 – Left-wing
- 600 – Right-wing
- 700 – Landing gear and landing gear doors
- 800 – Doors
- Note: MPD tasks are zone-wise.
- Fuselage Frames
- Total 87 frames – FR0 to FR87
- Ribs
- Wings Ribs – 27 ribs in each wing
- Vertical Stabilizer Ribs – 11
- Horizontal Stabilizer Ribs – 14 ribs in each side
- Access Panels or Doors
- Identification – Three figures which identify the zone
- Center if odd – LH
- Center if even – RH
- FWD PAX DOOR – LH – 831 ; RH – 841
- AFT PAX DOOR – LH – 832 ; RH – 842
- Cargo Doors – FWD – 825 ; AFT – 826
- Left emergency exit – FWD – 833 ; AFT – 834
- Right emergency exit – FWD – 843 ; AFT – 844
- Avionics compartments door
- 811 – FWD (90 VU)
- 812 – Lateral LH (oxy compartment)
- 822 – Lateral RH (battery compartment)
- 824 – AFT (80 VU)
- Accessory compartment access door – 312AR (AFT Equipment Compartment) (THS compartment)
- APU access door – LH Door – 315AL ; RH Door – 316AR
- Maintenance door- 314AR (APU air intake flap)
- Identification – Three figures which identify the zone